Topic

Hoop stay in Ohm 2.0

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
PostedFeb 11, 2015 at 6:54 am

A long time ago I tried a ULA circuit. I found that the hoop stay did not extend all the way to the bottom of the pack. It ended a couple inches above the bottom. I would have thought it would have gone to the bottom corner where the hip belt stabilizers attach. Can any one with the Ohm 2.0 comment the hoop stay in the this pack. Is it like the circuit in that the hoop stay doesn't actually terminate at the bottom of the pack?

Ian BPL Member
PostedFeb 11, 2015 at 7:04 am

My Ohm 2.0 is a couple years old. I assume nothing has changed.

Same as the circuit, the loop terminates into some grosgrain looking thing which is a few inches above the bottom of the pack. I think that the pack transfers weight to the hips perfectly so I don't see this as a problem.

Ken Thompson BPL Member
PostedFeb 11, 2015 at 7:06 am

From the ULA FAQ page

A: The suspension hoop used in the Ohm 2.0 is a minimal solution in helping you transfer load between shoulder and hip. If you imagine an upside 'U' you get a sense of how the hoop is positioned and how it functions. The upper arch of the 'U' ties into the shoulder straps, while each leg of the 'U' ties into the hipbelt. These points of contact allow for a range of suspension flexibility while being rigid enough to support loads up to 30 lbs. In addition, because the suspension is located to the periphery of the pack body, the backpanel is 'soft.' This results in a pack that can handle a load and does not dictate your body's movements — but rather responds to how you move.

Viewing 3 posts - 1 through 3 (of 3 total)
Loading...