Topic

Looking for food safe/waterproof adhesive…

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
PostedApr 4, 2010 at 5:57 am

I'm trying to convert a Platy plusBottle and Drink Tube kit into an upright hydration system that will minimize the risk of soaking the contents of my pack like an internally mounted bladder can.

I've taken a 1 liter bottle that will stand upright in an external pocket of my pack. I then trimmed off the drink tube to an appropriate length and ran it from my pocket to my shoulder strap where I can use it.

I thought I could just draw water from the bottle until it was empty. Unfortunately, this only works until the bottle is about 1/2 full and then it collapses and stops the water flow.

I tried attaching the excess drink tube to the bottom of the cap so it hangs down into the bottle and creates a really long straw. This worked reasonably well. The tube does pressure fit inside the cap reasonably well, but I'm thinking it might fall out when I'm hiking along and need a drink.

So the question is does anyone know of a food grade, waterproof adhesive I can use to attach a lengh of drink tube to the cap of my Platy bottle?

Here are the components I'm using:
http://www.cascadedesigns.com/platypus/handheld-hydration/plusbottle/product

http://www.cascadedesigns.com/platypus/platy-accessories/drink-tube-kit/product

Regards,
Greg

Eugene Smith BPL Member
PostedApr 4, 2010 at 6:19 am

I always thought that most 2-part epoxy adhesives were inert and thus food safe once fully cured. Of course in their isolated states it’s a mess. Also, a 100% Silicone caulking I believe would be fine for your project as well, preferably one labeled low VOC and no other additives like Microban etc.

Check out DAP 100% Silicone Bath and Kitchen Sealant. It should be food and water safe. I’m not a scientist and have no chemical background so everything I say is just my opinion, hopefully someone can chime in put down some facts. Here are the DAP specs on this adhesive, it meets some FDA requirement for food contact. It has a 100% Silicone Rubber polymer base which is the same silicone used in bakeware and rubber molds for cooking so I think its safe.

DAP 100% Silicone Sealant Specs & FDA Regulation

Viewing 3 posts - 1 through 3 (of 3 total)
Loading...