Topic

HMG mod for ice tools

Viewing 2 posts - 1 through 2 (of 2 total)
Cole Crawford BPL Member
PostedJan 25, 2019 at 10:50 pm

Looking to mod a SW 3400 to carry two ice tools. The single ice axe loop that runs right over the main compartment and smashes down anything in there is the biggest compliant I have with the pack. Been climbing more recently and this mod would be very useful. I don’t do much MYOG – suggestions?

PostedJan 25, 2019 at 11:47 pm

Hey Cole – make two small loops out of some strong shockcord, 3/16″ should be OK, and secure with a toggle. Each loop can be rigged through the little plastic loop tabs that are on the side of the back pocket. Use the lower loop like a normal ice axe loop and the upper loop to secure the shaft.

Viewing 2 posts - 1 through 2 (of 2 total)
Loading...