Anyone have instructions for making the aluminum back stays for a Gregory Z Pack Backpack? A diagram or complete direction would be great.
Topic
Aluminum Backpack Stays
Become a member to post in the forums.
- This topic has 4 replies, 2 voices, and was last updated 10 years, 2 months ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
Sorry, I do not, but perhaps it might be easier and more cost-effective just to see if they are available fromĀ Gregory ServiceĀ and Repair?
This application requires a very specific type of “spring aluminum” as McHale used to call it…
Thanks Bob Moulder, I have sent the info to their Service and Repair. We’ll see what happens.
I hope that works out for you, Arthur.
Found out a few minutes ago that the Gregory Z Series Backpack does not use aluminum back stays, but rather a wire U-shaped frame with an X reinforce in it. Don’t know if I can fabricate this or not. IF I had a picture I’m sure I could. Does anyone have a picture or a sketch of this wire support frame? I can do the measurement if I only knew what it looked like. PM me if you can help. Thanks for every ones help.
Viewing 5 posts - 1 through 5 (of 5 total)
Become a member to post in the forums.
advertisementYour privacy is protected: We do not transmit your user data to third-party ad platforms or advertisers, and we do not host third-party tracking pixels. Backpacking Light serves ads on its own custom, native, and internal platform.
New Ultralight GearSee the latest releases in ultralight cottage-brand gear from small makers.
