Topic

ULA Circuit Compression Fix

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
George F BPL Member
PostedNov 20, 2014 at 5:47 pm

I really like my ULA Circuit. While there are lighter packs out there the combination of capacity and comfort make it a keeper for me. It’s only drawback was with smaller loads like on a weekend or at the end of a trip. The single compression strap up high did not reduce the whole pack and allowed gear to slump into the bottom of the bag. So I came up with this:

Full Load

Half Compressed

Minimum Load

It allows the pack to be compressed quite flat and also pulls the bottom of the pack up while drawing it in, further aiding in stability. With light webbing and rings I doubted it added measurably to the weight and now when I am down to an overnight load the pack still carries trim and snug.

PostedNov 20, 2014 at 6:07 pm

Very nice.
I’m in the specification stage for a semi-custom Circuit, so this is good timing.

“… and also pulls the bottom of the pack up while drawing it in …”

Precisely where is the bottom ring, and how did you get there with a sewing machine?

Thanks.

George F BPL Member
PostedNov 20, 2014 at 6:15 pm

There is no bottom ring. The strap, and all other rings, is hand sewn. The bottom is as far as I could reach into the pack, it was a bit tight. For the top I just cut off the existing straps and sewed onto those.

PostedNov 20, 2014 at 6:21 pm

"The strap, and all other rings, is hand sewn."

A stout needle, some pliers(?), and a lot of patience. My compliments.

Viewing 4 posts - 1 through 4 (of 4 total)
Loading...