glue for gossamer gear pole grips?

Pour a good dab of Gorilla Glue inside the inverted grip. Coat the end of the pole shaft with mineral spirits, then quickly insert (before the ms start to evaporate). Give the grip a few 360 degree rotations to get an even coat, then let the rig dry inverted overnight. This should give you a solid glue plug which will keep the grips in place, and the mineral spirits makes putting the thing together easy.

I also used Gorilla Glue and mine are still holding strong.

Ryan

Thanks! That sounds easy enough to do….

I know this is an old thread but how did you widen the Gossamer Gear grips? Thanks

i used a screwdriver and just spun it around inside. Others may have better ideas….

A strip of 40 grit sandpaper, in a slotted 1/4" dowel, in a drill motor.

How much would you estimate you took off ? The hole of the grip looks really small compared to the diameter of the pole. I'm sure it needs to be a tight fit but… Alright, I'll try the dowel and sandpaper method.

Thanks!

I normally use extra hold hair spray from the dollar store. Trick I picked up from installing motorcycle grips. Spray liberally and it will help the grip slide on but once it dries it becomes sticky/tacky and keeps the grip in place

When I fit GGear grips to an 18mm OD BD pole I sanded the first inch out to 16mm.