TT Scarp Question

I haven't had the need to use the crossing poles on my Scarp 2 on a real trip yet, but the velcro seems like it would be ok to me. It might be a problem if it iced up and wouldn't fasten, but I think keeping it fastened should prevent that.

Hi,

You could always use some cable ties to make a loop to thread the poles through, I did this on my Scarp 1.

Cheers,

Stephen

This is a Scarp 2 set up without any mods…

Franco

Is that an SS1 one also Franco? if so thats 2/3 of my tent armoury :-)

hi Stephen
No that is my Notch

Franco, I was close but no cigar :-)

Run your poles INSIDE the Scarp's canopy from the apex of the corner CF triangle supports.

Sew small pockets above the apexes and insert the pole ends. (You will have to "cut-and-try" to get the poles to fit. Be SURE to only cut a little at a time until you get a snug fit. Use a small pipe cutter, available at hardware stores. Squeeze the cut sections from both sides repeatedly with a pliers until they break lengthwise to remove them. Leave the shock cords inside the poles.

Poles will likely not touch the very center of the canopy. This is OK as the outside sleeved pole supports this short area well.

To secure poles in place under the canopy sew Velcro cable ties to the inside of the canopy at the circular reinforcements where the outside pole ties are attatched and seal both sides very well. Smear it into the stitching with your finger. Water test when dry!

The great advantage to this setup is much more contact area for canopy support and the ability to set up crossing poles under the canopy when it's raining or snowing.

I used a similar setup on my Moment and it works great.