Topic

MYOG 8×7 cuben flat tarp – first time out

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
Tyler H BPL Member
PostedMay 6, 2012 at 8:14 pm

Had the opportunity to test out my just finished 8x7ish flat tarp. I made his out of Lawson's .74oz banana cuben.

Hysol is much more difficult to work with than I anticipated. If you have a nice big well-light and well-ventilated space to set out a massive jig then it'd be fine, but I do not and it was a struggle. So the construction was a bit sloppy, but it turned out fine and seemed to weather the probably 20 mph gusts last night.

Also got to test the John West/Borah Gear bivy, older Golite quilt and ridgerest combo down to the mid-20s at the City of Rock, Idaho.

tarp1

Not sure what to call this pitch but I've used it a couple times now and it's solid. Obviously, pitch the low end into the wind. If the tarp has a mid-panel tieout all the better to pull it away from your feet.

tarp2

Jerry Adams BPL Member
PostedMay 6, 2012 at 9:43 pm

Nice work, looks good

"Hysol is much more difficult to work with than I anticipated…"

Maybe it would be better to use tape? Even though it isn't as strong?

Maybe Hysol is better for smaller areas like reinforcement patches

Tyler H BPL Member
PostedMay 6, 2012 at 10:02 pm

So I used Hysol along the ridgeline and for the reinforcement patches. I sewed/hemmed the edges and sewed on the tie-outs. The corners have linlocs.

I would say yes, Hysol for the patches because it's no problem on the small areas. I did the whole ridgeline and clamped it. I left the boards clamped too long and it left particle board behind. Ugly.

I almost forgot, this thing weighs 5.5 oz without guylines. Kind of heavy for a cuben tarp but pretty much what I expected given that it's enormous and pretty beefy with the .74 oz cuben. You could fit two people under there too.

Viewing 4 posts - 1 through 4 (of 4 total)
Loading...