Topic

Pattern for bottom of pack

This topic is empty.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
Jun 23, 2011 at 3:15 pm #1275862

Brian Hall
BPL Member

@brian2o0o

Does anyone have a pattern for making the folds on the bottom of a pack? The pack I'm making will be a ion/burn hybrid. The cuts in the pack will be the same as the burn, but I don't understand the folds made to form the bottom of the pack. Any help would be appreciated, thanks!

Jun 24, 2011 at 5:48 am #1752795

Shane Bailey
Member

@shane112510

I don't have a Burn anymore, but if I remember, it seemed like the pattern would be something similar to this:

I don't remember what height the pieces below the bottle pockets were. If they were set higher than the bottom of the front panel side, you would increase the width of the two side flaps in the pattern.

I only had a Burn briefly, so I don't know if any of this is entirely correct. I do think it's similar though.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Loading...