Topic

Pole Expanders – Engagement/Locking

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
PostedApr 26, 2010 at 9:01 am

Engagement of the "rubber" expanders on adjustable carbon fiber poles has sometimes, for some people, in some circumstances, been problematical.

Water from creek crossings and inverted poles supporting rain shelters seems to be a common denominator, but I and my wife have experienced this with dry poles many times.

My Leki adjustable poles have a hard plastic barrel that has four splits, and when tightened against the mating cone, expands and locks. Most of the time.

When it has not locked I've pulled the poles apart and either whittled a "barb" or two into the plastic, or in a drastic move, shredded the side with the metal edge of my ski –

LekiExpander
The "roughness" then ensures enough engagement to achieve expansion against the cone.

With my CF poles at home, dry and clean, and expanders spinning easily, I have found that a half wrap of scotch tape adds enough diameter that parts engage every time. So only a very small amount of additional girth is needed.

But adhesive backed tape is not a good solution. Some are water soluble, some soften in heat. Most are relatively thick.

I have tried creating "barbs" with a scalpel, but the "rubber" expander material has such good memory it returns to "flat" offering no benefit.

I am considering painting on a very tiny "dot" of SeamGrip under the barbs to get standoff, and to protect the SeamGrip from peeling.

Before I take that step, does anyone else have ideas on how to accomplish this?

Thanks.

PostedApr 26, 2010 at 9:31 am

I get a good lock on my CF poles every time by doing the following:

If I can't seem to get a lock (the thing just keeps on turning), then I hold the bottom piece right at the point it meets the top piece (in effect marking the desired length), then remove the bottom piece entirely, ensure the rubber expander is nearly flush against the carbon fiber (ready to lock), then re-insert the bottom into the top rather quickly (you can feel the air resistance) right up to where I'm still holding it, and twist to lock immediately.

This has never failed me.

EndoftheTrail BPL Member
PostedApr 26, 2010 at 9:35 am

My GG LT4 poles haven't ever failed to lock.

Of course, now that I said it….

PostedApr 26, 2010 at 9:39 am

If I unlock my GG poles to much they will not twist lock again. Now I twist just enough to move them and the locking rubber has enough friction to grab and lock.

Viewing 4 posts - 1 through 4 (of 4 total)
Loading...