Topic

Ttt Double Rainbow 2010 quick tour

  • This topic is empty.
Viewing 10 posts - 1 through 10 (of 10 total)
EndoftheTrail BPL Member
PostedApr 22, 2010 at 8:32 pm

Very nicely done! I really like the wider space and the two genuine vestibules (instead of 'big beaks').

PostedApr 22, 2010 at 9:33 pm

Thanks Ben
now that I am back from my bike ride, it is confession time.
I set up the tent and shot the video in less than 15 min because I have lunch as I watch the midday news…
Then i edited the video , uploaded that and went for my ride trying to beat the rain.
The rain came , it felt like London is summer.
So there are several set-up errors that I could not be bothered fixing.
Two of the guyout points are not at the correct angle and the floor is not clipped in correctly.
You can see that by the waves in the floor and the very uneven tension. Mostly this is cosmetic, nevertheless it isn't correct.
This is the correct way to clip the floor up…
Corner tie out

Franco

Travis L BPL Member
PostedApr 23, 2010 at 3:58 am

Franco, what did you do to get the vestibules pitched that low? Is that something new with the 2010 DR, or is it all in the pitch?

PostedApr 23, 2010 at 2:51 pm

Possibly the draught is over. We have had some decent rain in the last month or so. Rained again during the night, I was inside the Moment with my two cats…

Travis
I have not had a DR before, so I am not sure about this.
My Rainbow is a very early test-production run, so lots of differences with the latest.
Franco

Konrad . BPL Member
PostedApr 23, 2010 at 8:18 pm

Hey Franco, i just got my 2010 rainbow, but haven't had a chance to pitch it outside of my living room floor. I was curious about the lower pitch as well. I know you have an earlier prototype, but I was curious to know if this pitch was achieved just by pulling out the beak at a different angle, or did you have to do something else ( i.e. clip something up/down, loosen/tighten the tieout/toggles at the 4 corners, etc) before pulling out the beaks.

PostedApr 23, 2010 at 8:59 pm

Konrad
I cannot do that with my 2005 Rainbow.
As for the 2010 DR I just went downstairs and pitched it low.At that point I did not know how low it could go, so what you see is my first (and only) attempt at that. As explained above I did not really do a good job of it but it was OK , so filmed that and then let the tie out points out and that is how it goes back to the standard set up.
So the first shot in the video was actually the last to be taped. If you look carefully you can see that the pegs in the opening shot are several inches away from the fly, in the "low pitch" they are by the fly.
I will have a 2010 Rainbow soon , so I will do a tour of that too. This time I will allocate more than 15 min…
Franco

Viewing 10 posts - 1 through 10 (of 10 total)
Loading...