Topic

TT– Rainshadow 2– Set Up

  • This topic is empty.
Viewing 16 posts - 1 through 16 (of 16 total)
Jay Wilkerson BPL Member
PostedApr 19, 2010 at 4:16 pm

Any hikers out there own the Rainshadow 2? I have one on the way-I read a few reviews and look forward to trying it out with friends and family…Any set up pointers I need to now? I read: Point the lower end toward the breeze for better ventilation- What else? What about the bathtub floor set up with the internal clips?

Thanks-Jay

PostedApr 19, 2010 at 4:36 pm

My wife and I use a Rainshadow 2 when we go out together.

Practice setting it up. Get comfortable with how to adjust the lines, etc…

We are quite happy with it and have endured some snotty weather.

It is nice and light, has good ventilation, you can pitch it low if you want to keep the blowing snow/rain out or pitch it high for muggy summer heat.

PostedApr 19, 2010 at 4:41 pm

Like any shelter with slippery silnylon floors, it helps hold your sleeping pad in place if you apply some patches of some type of grippy material to the floor.

Otherwise you slide to one end of the shelter when on a slope. When are you not on a slope?

We used 10×1 thinned silicone, but there are many options

Jay Wilkerson BPL Member
PostedApr 19, 2010 at 8:42 pm

Thanks Steven or the info. There has to be a few BPLers who own this Tarptent–Any set up tricks are advice on setup versions? What about the bathtub floor clips???

-Jay

Skip Booth BPL Member
PostedApr 19, 2010 at 10:37 pm

Jay,

I own the Rainshadow 2 as well and have been very happy with the tent.

As to tips/tricks, I'll be honest setup of this tent is about as easy as it gets. The bathtub floor clips are simple to use and you won't have any issues with those. In good weather I prefer to have them unclipped so the floor lays flat and there's more space.

I prefer using 2 trekking poles instead of one as it's more stable in wind and you get a more unobstructed entrance as you don't have a pole right in the middle. It requires a little more coordination to setup using two poles IMO but it's far more stable. Start out with the 2 poles pointing into the center and then rotate them outward once you have tension on the center stake out line it works pretty well.

The only other thing that requires practice is the velcro on the doors. I find that if I velcro the doors loose and then clip them to the center line it works better and is easier to align.

This tent is so simple though, it's really about honing your technique to reduce the setup time down to under 2 mins :) I actually struggle more with getting the Rainbow 2 back into the original stuff sack. Since I use the Tyvek floor and roll that up with the rest of the tent, I needed a slightly larger stuff sack than what Henry supplies with the tent.

One other piece of advice is to make sure you have selected a tent location which is big enough. The space needed to set this tent up is surprisingly large and I've been caught having to move it on occasion when I've underestimated the amount of space I'm going to need to adequately stake out the tent.

PostedApr 20, 2010 at 5:13 am

Ive recieved one recently and it looks good. A few questions for users.

How bad can the weather get before she starts blowing rain into the inner from the end?

Also how do you pitch it low at the rear?

Lastly theres a clip on the back right corner…whats it for?

PostedApr 20, 2010 at 7:49 pm

Hi Richard,

As far as blowing rain goes, I've experienced it from all sides. I have only had issue with a very small amount of spray coming in at the foot and that was during strong horizontal rain conditions. The mesh caught most of it.
We have had more come in the front/head and a little in the sides, but even that wasn't enough to worry about in the worst conditions.

You don't have much variation in how you can pitch the foot end, but the sides and head can be pitched low if you are in stormy conditions and think you need the extra overhang.

We have pitched it too low for fear of the rain and ended up with probably more condensation than spray.

Our experience has shown to not worry about the spay and just make sure you pitch it on high ground so you don't end up in a puddle:-)

PostedApr 20, 2010 at 7:50 pm

I'm not sure what the rear clip is that you are talking about and can't open mine up right now.
Is it mentioned on the documentation at the Tarptent site?

PostedApr 21, 2010 at 1:58 am

Thanks for the reply Steven.
Good to hear that only a little rain comes in with horizontal storms. They were the ones I was worried about.

Ive reread the online instructions and still no mention of the rear clip.
All I think it can be for is to tension the tent over the rear pole….? Or possibly to lower the tent corner an inch….? Or maybe just make it easier to put the pole in…?

Heres some photos to help the discussion along.
Without tensioning the strapStrap tensioned

PostedApr 21, 2010 at 2:50 am

Richard
Those ladder locks are mostly there to compensate for the elasticity of silnylon.
Silnylon stretches when wet and or cold (as in your picture) and shrinks when hot and dry.
So always try to pack the shelter having undone those ladder locks, and then tension them as needed. If you leave the shelter up in the morning, let it out again to allow the fabric to shrink.
Franco

PostedApr 21, 2010 at 4:03 am

Ahhhhhhh….Ladder locks. Ive heard of them before, just never seen one before.
Thanks for the headsup Franco.

PostedApr 22, 2010 at 12:51 pm

Last summer I went through 2 strong summer afternoon lightning- wind-rain-hail storms in the Rainshadow 2 with 3 people inside and all our gear. The camp sites were fairly open but not wide open. I chose the most protected option for what was available. Both storms put the heaviest wind gusts from the side or quartering to the rear and not directly up from the foot. My mistake I suppose, I was a little wrong in anticipating the storm direction. These were very heavy gust storms with swirling winds. I was seriously concerned that the back hoop pole was going to break. The front was pitched with two trekking poles. The sides were staked out. The tent was pitched low. Persons and gear were huddled together at the center of the tent. I was doing my best to hold the tent upright (from the inside) and keep the back pole from snapping. If that pole snaps I would bet the fabric would start ripping right away and then you are outside…

My back pole was bent permanently out of shape. I was left thinking that the storms would have been survived better under a Ray Way style tarp that does not have the same side wind weakness and no thin poles to snap.

But that said I think for the weight and convenience of setup the tent is excellent within it's limitations for 3 people. It provides excellent bug protection, comfort, and adequate rain/wind resistance for summer mountains use in protected campsites. Wind protected campsites with ground cover that will minimize rainsplash are optimal. Open campsites on hardpan soil with swirling winds will leave you unsatisified.

If I continue to use the tent this summer instead of making a RayWay 3 person tarp and net tent I plan on adding some Jacks R Better Grip clips to the kit and putting them on the sides to increase strength for the back pole. http://www.jacksrbetter.com/GripClips.htm

PostedApr 22, 2010 at 1:40 pm

I've been using the RS2 constantly since last fall, under lots of weird conditions, including 2' snowfall.

The key with the RS2 is site selection, as others have stated, but more important than that, is really making sure you get the rear arch facing the wind. The sweeping sides don't shed direct wind without putting a serious dent in the active floorspace of the tent, staked out or not, and no matter how tight a pitch.

In harsh wind, the two trekking pole pitch seems almost mandatory to me.

Also, the trick to getting the end pitched low in driving rain or heavy backsplash is to dig small holes under the ends of the arch poles, and it may help in that situation to unclip the floor elastic at the rear.

I like my RS2, but I wish there were more 3-person (2peeps and a huge dog) options out there.

PostedApr 23, 2010 at 3:25 am

Good input Brendan and Javan.
Those are the sort of conditions I was afraid she might fail in Brendan. Sounds like it did the job though, albeit, just. These Jacks R Better Grip clips look fantastic! Is there a chance that they could put a tear in the fabric? They look too good to be true.

PostedApr 23, 2010 at 4:28 am

I have used the grip clips in a similar fashion. Be aware that they slip on silnylon unless backed with something grippy. I'm also afraid that they could actually wear the silnylon to the point that eventually water could seep through around where the grip clips have stressed the fabric.

I am considering the mod in the link at the bottom of this post.

I agree that probably the weakness of most shelters of this type is when you get that side wind pushing the sides in. Having extra ties can make the difference in wind handling in any shelter.

http://www.backpackinglight.com/cgi-bin/backpackinglight/myog-laminating-silicone-impregnated-fabrics.html

Viewing 16 posts - 1 through 16 (of 16 total)
Loading...