Topic

Ray Way Tarp kit out of cuben?

  • This topic is empty.
Viewing 6 posts - 1 through 6 (of 6 total)
S Long BPL Member
PostedApr 16, 2010 at 9:28 pm

I caught the MYOG bug and want to make a tarp shelter. The Ray Way tarp seems pretty simple and effective, but I am wondering if anyone has made one out of cuben? It seems a superior fabric. More water resistant and won't stretch. Also, it can be bonded/glued instead of sewn. I also was wondering if a catenary curve on a Ray Way tarp out of cuben would be a bad design addition or not. Thanks for any input or thoughts on the subject.

Travis L BPL Member
PostedApr 16, 2010 at 9:33 pm

Cuben has its benefits over silnylon, but abrasion resistance is not one of them. Other than that, you could make pretty much any type of 3-season shelter out of cuben.

PostedApr 17, 2010 at 4:56 am

Cat. would be good if you think you are always going to pitch it the same way. It optimizes the tarp for a particular pitch, but makes it less flexible than a flat ridge.

S Long BPL Member
PostedApr 17, 2010 at 12:32 pm

Doesn't the Ray Way design already lend itself to being pitched the same way each time with the inclusion of beaks on both ends? High or low seem to be the only options.

Mark Ferwerda BPL Member
PostedApr 17, 2010 at 4:16 pm

I sewed up 2 Ray Way taps, 1 with a straight ridge line and the other with a catenary curve. If you use the side lifters as intended, you lose a bit of headroom with a cat. ridge vs the one with the straight ridge. Even though the tarp with straight ridge is a little bit heavier, I tend to use that one more often simply because I like to be able to sit up in it. Of course it depends on how high you set the ridge line, but using a normal setting, I can only sit up near the ends in the tarp with the cat ridge.
Mark

S Long BPL Member
PostedApr 17, 2010 at 4:50 pm

Thanks for the insight. I think I will go with a straight ridgeline and maybe experience with a cat cut sometime down the road.

Viewing 6 posts - 1 through 6 (of 6 total)
Loading...