Topic

Adding down to an old bag

  • This topic is empty.
Viewing 9 posts - 1 through 9 (of 9 total)
Miles Barger BPL Member
PostedFeb 28, 2010 at 9:56 pm

Any companies out there that will add down to an old bag? Specifically, I'd like to add a few ounces of overfill to my WM Summerlite.

PostedFeb 28, 2010 at 10:34 pm

Call WM and see if they'll overfill it for you. Mught be the cheapest way to go. The next cheapest may be to sell it and buy a new one that WM can overfill when it's being made.

(But then, if the bag is in sad shape otherwise, adding new down may be like putting lipstick on a pig, as the saying goes.)

PostedMar 1, 2010 at 6:51 am

This may be OT, but how easy do you guys think it would be to do it yourself ? Unstitch the bag on one side where you can push some more/new down through, then stitch it close again; I'm not so good at stitching but it sounds doable to me. What do you think ?

Brad Rogers BPL Member
PostedMar 1, 2010 at 7:17 am

You can try, but I called WM and they said they couldn't/wouldn't add any down to a Summerlite. They said they only did overfill on the Ultralite and up.

If you really want more down you could send it to rainy pass (rainypass.com) as they will add down to any bag.

Miles Barger BPL Member
PostedMar 1, 2010 at 9:37 am

I should say that the bag is definitely not in bad shape. I've had it for almost 4 years, and it's as lofty as ever. I'd like to overfill because the down has a tendency to shift more than I'd like. It'd likely add a few degrees to the temp rating, as well, which would be nice.

Joe Clement BPL Member
PostedMar 1, 2010 at 10:12 am

I thought I had seen someone on here send a bag to Downworks in Santa Cruz? for more down.

Cesar Garcia BPL Member
PostedMar 1, 2010 at 10:23 am

I added more down to the footbox of my cheap down bag and it came out great. The stitching looks like crap but its on the inside of the bag so no big deal. It also looks bad because the thread color doesnt match the material but again its on the inside so it doesn't show.

All you do is use a seam ripper and open up a seam. Then used tape to hold it closed while I prepare the down to be added via shopvac extension and netting. Sucked up the down and blew it in. Repeated and then stitched it back up. Did the same for two other baffles.

Oh and I was told to use a backstitch when stitching it back up.

Viewing 9 posts - 1 through 9 (of 9 total)
Loading...