Topic

perfect heineken pot holder – almost

  • This topic is empty.
Viewing 6 posts - 1 through 6 (of 6 total)
PostedFeb 18, 2010 at 5:47 pm

so I was walking through my local Chinese supermarket and came across these – they are apparently used for steaming… Stainless Steel and a whopping $4. Perfect height, perfect for a frying pan on top as well, if need be.

Problem is ring is 1/16" too small for the pot to slide into.

Should I grind it? Heat it & stretch it?

Just sooooo close

No weight, as I don't have a scale, but it's not much!

heiny pot 1

heiny pot 2

obx hiker BPL Member
PostedFeb 18, 2010 at 6:01 pm

Shooting from the hip. Looks like you could cut through the ring between each pair of side brackets and that would allow the ring to spread just enough but still brace the heine can. You'll have 3 brackets which can be slightly bent up or down to provide the extra 1/16th inch

obx hiker BPL Member
PostedFeb 22, 2010 at 11:38 am

Boba,

You cut through at all 3 sections between the brackets holding the inner ring to the outer ring? And couldn't move the 3 sectiond up or down enough to fit the heinekin?

Got a photo?

Hiking Malto BPL Member
PostedFeb 22, 2010 at 12:34 pm

remove all three sections of the ring between the supports. Then you can bend the supports to increase the diameter. And it's lighter

Simon Weiss BPL Member
PostedFeb 22, 2010 at 11:25 pm

Not sure how these cans differ in size, but maybe his enought to fit

I'd really like one of these. I'll have to check out one of the everything-aria stores nearby.

Nice find!

Viewing 6 posts - 1 through 6 (of 6 total)
Loading...