Topic

Repairing a Catalyst

  • This topic is empty.
Viewing 8 posts - 1 through 8 (of 8 total)
PostedFeb 15, 2010 at 6:35 pm

I have a 2008 Catalyst pack that I just noticed has a 3/8 inch hole in the bottom – possibly granite induced. Would Kenyon nylon repair be good to use, or can anyone recommend anything else? Thanks so much – Barbara

PostedFeb 16, 2010 at 4:29 pm

Thanks Franco – I did – and they were very helpful – I wondered what others have done and how it worked out. B

Bob Gross BPL Member
PostedFeb 16, 2010 at 4:31 pm

I don't have that particular model of pack, but I have one very similar. If mine had a 3/8" hole in it, I would probably use a 2×2" square of Kenyon tape applied to the inside of the pack, directly over the hole. Then, with a sewing machine, I would do a little bit of bar-stitching around it. I would try to use Kenyon tape that is halfway close in color, and I would use strong thread that is close in color. But that is just me.
–B.G.–

David Chenault BPL Member
PostedFeb 16, 2010 at 7:05 pm

3/8" is not that big. Tear off a piece of duct tape. Heat the adhesive slightly with a candle or lighter. Stick it to the inside of the hole, centered. Put a fat dab of aqua-seal over the outside of the hole. Let cure overnight. Done.

PostedFeb 17, 2010 at 12:36 am

Barbara,

I had a similar problem ( a mouse chewed through the rolled top of my ULA OHM). I chose to go the Kenyon Repair Tape path. So far so good. I just applied a strip on both sides of the hole to be sure. GL

Viewing 8 posts - 1 through 8 (of 8 total)
Loading...