Has anyone used the UL version of the Caldera Cone? I wondering how efficient it is compared to the original. If there's that much of a difference, I think I might just go with a canister stove because I'd still like to fit everything inside a 700ml pot.
Topic
Caldera Cone ULC
Become a member to post in the forums.
- This topic is empty.
I haven't done extensive testing… a bit in the backyard, and a bit in the back country with several stove / pot combinations. For me to get 16oz of ~50F water to a rolling boil in modest winds I found that the UL Caldera + MLD 850 pot typically took around .6oz fuel, the standard caldera + BPL 550 pot took around .5oz of fuel, and my Ion Stove + Evernew 900ml pot (wide bottom) used around was the fuel efficiency champ at a bit under .3oz of alcohol provided I was willing to wait 15 minutes to get to a boil. I found that I could boil 16oz+ of water using a .5oz esbits using either the UL Caldera or standard Caldera.
–Mark
I have the UL Caldera for a Snowpeak 700. I've had similar results as Mark. I typically boil 10 to 12oz for the meals that I'm rehydrating. I can get the water to a boil on 0.4oz of Heet. I haven't used a full Caldera cone for comparison.
Prior to using the Caldera UL I used a Snowpeak LiteMax with a SP600 or SP700 depending on how the mood struck me. Both systems have their benefits. I'm currently using the Caldera because of the simplicity and flexibility on the amount of fuel that you carry with you. There are a few threads on BPL calculating out the break-over point when carrying alcohol is heavier than canister fuel. If I recall its around 4 or 5 nights for a typical solo hiker.
Don Meredith
http://lightpack.blogspot.com
I've used both the regular Caldera Cone and the ULC. While I've never took specific measurements, the difference is not noticable. I can easily boil 16 oz of water with 15ml of fuel in either set up. I'm sure that having some of the pot outside of the cone (like the ULC) makes it slightly less efficient, but it's really not significant. Certainly not enough to justify going to a (gasp!) canister.
I recently began using a method suggested by Franco with my Caldera UL Compact setup. Put more alcohol in the stove than needed to make it run more efficiently. Once you get a boil, just snuff out the stove with a homemade snuffer (aluminum foil) and put the remaining fuel back into your fuel container. I don't have the full size Caldera Cone to compare but my UL Compact Cone is plenty efficient. The difference in efficiency between the two cones is probably not noticeable.
-Sid
I guess I'll be skipping the canister. Now I just need to find a fuel bottle that will also fit in the pot. I haven't had any luck finding a Little Nipper.
I've never really considered it but maybe one of those GU flask squeeze bottles for short trips. They hold 5.5oz of GU and weigh 0.6oz. The pull top should be able to seal well enough to prevent leaks but I'd test it before hitting the trail.

> Now I just need to find a fuel bottle that will also fit in
> the pot. I haven't had any luck finding a Little Nipper.
Check out http://www.easytravelerflask.com — they have a whole bunch of small containers, including flasks (http://www.easytravelerinc.com/flasks.aspx)
(I have some; that's what I carry my alcohol in.)
— Bob
Thanks for the link Bob. I've been scouring the internet looking for something like this:

It holds 8 oz. and looks like it'll fit into my pot along with the stove and cone.
Become a member to post in the forums.

