Topic

Refurbishing DWR on Jacket

  • This topic is empty.
Viewing 6 posts - 1 through 6 (of 6 total)
PostedFeb 2, 2010 at 5:11 am

I have an older EMS System III rain jacket that is in dire need of a new coat of DWR. I have not had good luck in the past with products I have purchased so I am looking to those more experienced than I for advice on what to use. It's current state is that it will wet out rather quickly.

Konrad . BPL Member
PostedFeb 2, 2010 at 8:48 am

I presume youve tried nikwax products? If not, do that first. I've never used the spray on products, but have used the wash-in ones. I've heard the spray on is more effective….maybe a combination of wash in, and then spray? Also, are you drying your jackets after treating them? I find light heat from the dryer as a good way to activate fresh dwr treatment, as well as reactivate old DWR

PostedFeb 2, 2010 at 9:31 am

Nikwax is a waxed based DWR. It works pretty good but it only lasts about 1/2 as long as a synthetic based DWR like most others (ie. Grangers).

In general, I prefer the spray on DWR's and then I load them on with several medium coats. I give the jacket about 5 min between coats to absorb the DWR. With a synthetic DWR you want to toss it in the dryer for a long time to heat activate the DWR but I'm told this isn't necessary if you are using Nikwax since it's wax based. Make sure your garment is clean and slightly wet when you start.

PostedFeb 2, 2010 at 8:15 pm

I did try some spray on Nikwax a couple years ago. It seemed like it didn't last but maybe a month. I re-applied but it was gone again by the end of the summer.

I looked at the Grangers product but didn't understand the "heat activation". I appreciate the explanation between the two. I think I'll give a try with Granger and see what happens.

Richard Lyon BPL Member
PostedFeb 3, 2010 at 7:21 am

Atsko (which makes Sno-Seal; http://www.atsko.com) makes a great DWR-restoring product, Water Guard. Wash the jacket with non-detergent soap (Atsko Sport Wash, Ivory flakes), spray on the Water Guard, air dry until damp and then dry in the dryer at medium or high heat. Cleaning the garment and drying in the dryer by itself helps any DWR.

Viewing 6 posts - 1 through 6 (of 6 total)
Loading...