Topic

OR Latitude/Endeavor Mitts + PL-400 Gloves

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
Brett Peugh BPL Member
PostedNov 28, 2009 at 10:40 pm

Personally I use those REI shell Mitts with a pair of PL-300 mitts and some really thin wind pro gloves so I can have the whole range if needed for movement and warmth. Layers can come an go as needed then.

BTW, if you use all together you are well below freezing, especially when moving.

PostedNov 29, 2009 at 1:21 pm

I use the Latitude mitts – just the shell, I don't use the gloves that came with them since they are relatively heavy for the warmth they provide – with a pair of mittens my friend's mom knit for me in 1973 and some powerstretch liners. all three together is way warm, mostly I use the liners alone or the liners with the shells, occasionally the mittens with the shells. This is for Sierra Nevada weather, fall through spring. I like the 3 piece system, as it gives a wide range of possibilities. To me, the PL400 gloves would be too heavy – If I need that much warmth I'd rather have a mitten which would be lighter for the same warmth. I have used a variety of liner gloves with this system over the years – all wool, wool/ploypro, all polypro, and now the powerstretch – and a couple variations of the shells, mostly homemade, and the knit mittens have been the one constant for about 37 years now. I finally switched to a store-bought shell when I had a real seam leakage problem with my last pair of homemade shells. Mitten shells are easy to make but hard to seal those seams!

Viewing 3 posts - 1 through 3 (of 3 total)
Loading...