Topic

Seam Sealing a Bivy

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
Sanad Toukhly BPL Member
PostedNov 26, 2009 at 7:18 pm

Is it necessary to seam seal a bivy?

I feel like this is just adding unnecessary weight. The way I see it, there are only two ways I can think of where water would get in through the seams. You would have to either be in a puddle of water because of bad site selection, or be getting heavily splashed with water because of a bad storm. The latter can be prevented by pitching the tarp low enough.

You also must consider that a bivy top is water resistant, not waterproof. So in either one of the scenarios I mentioned, the top of your bivy will wet through anyway and the water getting in through the seams will be the least of your worries.

I would like to hear your input. Do I really need to seam seal my bivy?

-Sid

Tim Marshall BPL Member
PostedNov 26, 2009 at 10:26 pm

nope.

If the top of your bivy isn't waterproof then seam sealing the seam that connects the water proof bottom to the non-waterproof top is useless. IF water can get in the top what is another 1/4" under that really saving? IT may be worth it (depending on bivy design) to seal any vertical seams in the foot or head area however.

-Tim

Sanad Toukhly BPL Member
PostedNov 27, 2009 at 8:54 am

Thanks Tim,
that's what I thought too. I think I will just use it without any seam sealing for now. If I notice water getting in from certain seams, I can always take care of it later on.

-Sid

PostedNov 27, 2009 at 10:14 pm

I think Outside mag polled "experts" on this some time ago. Gear manufacturers and the like. Do they seam seal in real life? Divided 50-50.

Tim Marshall BPL Member
PostedNov 28, 2009 at 4:23 am

the reason they are split is because half the big companies bivys are full waterproof so seam sealing makes perfect sense for them. Without a waterproof top it is really not doing anything but adding weight to seams seal the top to bottom edge.

-Tim

Viewing 5 posts - 1 through 5 (of 5 total)
Loading...