Topic

Gear Zipper Health

  • This topic is empty.
Viewing 7 posts - 1 through 7 (of 7 total)
Ron Bell / MLD BPL Member
PostedNov 23, 2009 at 5:31 pm

Public Service Announcement…

Don't forget to keep your gear zippers clean and lubbed!!!

We repaired a Mid zipper the other day (very rare) and wanted to share with folks it's story.

Mid came in super dirty and dusty – yeah- we know the whole story now… too many adventures and no time for zipper love… Like an outlaws horse, 'shim' had been rode hard and put away wet…( well – mostly dirty and way more than once…)

Bad News: The aluminum slider was all worn out and would not join the teeth anymore…waaaaa …All the dirt and dust on the teeth from hard dirty trail duty had abraded the slider and worn it out. The once proud black #5 YKK dual side slider was a dull gray sad abraded aluminum thingy…

Good News: The teeth and WR fabric teeth edges were in perfect condition!

All we had to do was pop a couple stitches at the top and slide on a new slider and it was good as new. It could have been done in the field in about 5 min too!

End PSA

PostedNov 23, 2009 at 9:11 pm

Is beeswax acceptable? It is recommended for leather flight jackets that cost just as much as good gear…

Roger Caffin BPL Member
PostedNov 23, 2009 at 9:19 pm

Beeswax is thick enough to retain dust and sand. BAD news.

A clean dry zip is usually all you need. Gooey lube is NOT what you need.

Cheers

David Chenault BPL Member
PostedNov 23, 2009 at 9:50 pm

On high-use zippers I put a bit of Tri-flow on, run the zip back and forth a few times, then wipe with a clean, dry rag.

PostedDec 9, 2009 at 2:59 pm

I don't use beeswax on any backpacking gear. Bears are supposed to have a strong attraction to the smell. I wouldn't want a bear ripping off my zipper:-)

Viewing 7 posts - 1 through 7 (of 7 total)
Loading...