Topic

thoughts on the AGG tin man stove

  • This topic is empty.
Viewing 7 posts - 1 through 7 (of 7 total)
Matt McEwen BPL Member
PostedNov 8, 2009 at 11:37 am

I am considering this stove with the priming pan for short trips(3 nights or less) in the north Ga/NC mountains. I would use it with a .9L or 1.3L pot.

Any of you folks have any experience with it? Thoughts?

Thanks,
Matt

PostedNov 8, 2009 at 12:31 pm

That's probably a fair price for the work they put into it, but if you're strapped for cash, you can make the same setup mostly from stuff you'd throw away anyway. If you aren't confident in your skills, you can get roughly the same heat output by cutting the bottom off a soda can, and stuffing it with fiberglass insulation. Pour in an ounce of alcohol and you're good to go. You'd need a separate pot stand though.

This particular setup has side jets so the stove can act as a pot stand. That can be problematic in winter. Setting the pot directly on the stove has been known to cool the stove to the point where it goes out. This problem is usually solved with a separate pot stand or by laying a couple of pieces of coat hanger wire across the top of the stove to separate the pot from the stove or by holding the pot above the stove until it warms up a little.

Matt McEwen BPL Member
PostedNov 8, 2009 at 3:42 pm

Hey thanks again Keith, especially for the coathanger tip.

You know you can buy the items a la carte…the stove and priming pan comes to only 17$

John Devitt BPL Member
PostedNov 8, 2009 at 3:53 pm

I have been using the org pepsi stove Tim first sold for 7 years now and it still works great. I bought a back up one 2 months ago.
Regards,
John

Mark Verber BPL Member
PostedNov 8, 2009 at 6:58 pm

I used a tin man stove for .5-1 year. It was a perfectly serviceable stove. If I wasn't such a gearhead I most likely would have stuck with it and would be another 7 year user.

I ended up switching to the ion stove (and then the ul caldera cone) because they were a bit easier to use and more fuel efficient. With the tin man you have to light the stove and then wait for the jets to fire up before you place the stove down. I also found that a .9l pot seemed a bit precarious on the tinman and the 1.3l really felt too large. I had trouble centering the stove on the bottom of the pot. I can be a bit clumsy. I accidentally knocked my pot off the stove once and it was a near thing several times.

–Mark

Viewing 7 posts - 1 through 7 (of 7 total)
Loading...