Topic

Double use stove cone

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
PostedOct 29, 2009 at 12:05 pm

Hey all, I just maimed my Caldera Cone ;)

I bought it to use with my Ti mini solo pot… but I figured… why not also be able to use this with the Heiny can pot I made for fun(wasn't gonna buy another cone). So… I measured where the pot bottom fell when inserted into the cone, and drilled the tiny holes so that titanium stakes could slide through and support the Heiny can.

Anyhow, I didn't post this as a "look what I did", because this is so silly compared to the cool things I see so many of you doing with gear on here… I more or less had a question:
Am I supposed to use one or two esbit tablets in the Gram Cracker to bring water to a boil? I used one tablet… and it just did the 'tiny bubbles' thing to 16 ounces of water after about eight minutes. Water was 205 degrees F. I suppose that is good enough for a freezer bag meal. Esbit tab was gone by 12 or so minutes. Elevation 3000ft. It was windy out, 50 degrees and the water was cool to begin with. Are those poor results? I am used to my Vargo Jet Ti canister, So I am new to esbit and cones…
Thanks!can and cone

Rand Lindsly BPL Member
PostedOct 29, 2009 at 12:38 pm

It does sound like your performance is a little off assuming you are using both side wings on the Gram Cracker. Using them slows the burn and increases efficiency. I typically get 2 cups to boil on somewhere between a 1/2 and 2/3 of a tablet depending on altitude and water temp.

Now, with that said, using a Heinie can in a cone that does not snug up tight to it….in addition to the large handle cutout….does allow a lot of the heat to escape without necessarilly heating the water. Also, with the taller/skinnier pots/cans, it is VERY important to get your stove/GCracker directly under the the pot. If it is offset it will just vent straight out. Also with all the opening in this configuration you will get more wind impact.

Hope that helps!

Rand :-)

PostedOct 29, 2009 at 12:53 pm

Yep Rand… both wings. I figured the results were weak… as you stated, lot's of gaps. Just thought I would experiment. But I do dig the potential here… and suppose I should just order one of your Keg systems! Would I use the H-system if I wanted to be able to replace the can, should it get dinged/ruined? Thanks! …and sorry I maimed your cone ;) I'll still be using it with my Ti solo pot!

Rand Lindsly BPL Member
PostedOct 30, 2009 at 2:38 pm

Not a problem….doesn't look too maimed from here! :-)

You can replace the can in any of the Keg systems. We send a "formed" Fosters can with the Keg-F and the Keg-GVP where the formed lip is what supports the can on top of the cone….but we also send along the large "Beer Band" that you slide onto your own Fosters can if you like and it will take the place of the formed lip. The Keg-H….using the Hinie can is sturdier and doesn't require the caddy.

Your call!

Rand :-)

Viewing 4 posts - 1 through 4 (of 4 total)
Loading...