Topic

Water Bladder Threads

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
PostedOct 8, 2009 at 10:09 pm

A couple quick questions.

1) Are the threads on the platypus and evernew bladders the same? i.e. can a tube and cap for each system be interchanged between the two bladders?

2) Does anyone sell just the cap and the 90 degree ribbed fitting?

3) Do the tubes have approximately the same inner I.D.

Finally, with lightweight in mind how do most of you approach your drinking water both on the trail and at camp. Leave out filter discussions.

Do you drink from a hydration tube while hiking? Do you carry just a single 2 L bladder? etc.

PostedOct 8, 2009 at 10:28 pm

I carry a larger platypus for in camp use or if I'm going to a dry camp, and generally carry one or two 1 liter platypus' for drinking on the trail. Reused plastic water or gatorade bottles are also just fine.

As for the tube, I think it is a matter of personal preference – I tried drinking from the hydration tube for quite a while but never really liked it. Plus it was hard for me to manage my water intake as the bladder was generally buried in the pack and I never knew how much water was left.

PostedOct 9, 2009 at 6:46 am

I don't know about the thread compatibility. I can tell you that a cap from a 16 oz. soda bottle will fit a platypus. That fact saved me a couple of bucks when I had to replace a lost cap. Anyway, that gives some hope that thread size may be standard. Sorry I can't give you a definitive answer.

I use the tube. It's right there and I can drink without stopping and my hands are free to hold my hiking poles. Water management hasn't been an issue. I start with 3 liters and it always lasts all day.

With the bladder in the pack next to your back, it's not likely to freeze. The water in the tube will freeze however, so it's a good practice to blow just enough air to clear the tube after a drink.

Viewing 3 posts - 1 through 3 (of 3 total)
Loading...