3D printing of MoLLE attachment for Insta360 ONE X2

[Nenta WAKO, Dr.Eng.]

Companion forum thread to: 3D printing of MoLLE attachment for Insta360 ONE X2

I made MoLLE atachment parts to mount Insta360 ONE X2 to my backpack.

I desiged the shapes of the GoPro mount and a holder for selfie stick. Then ordered it in a 3D printing service. The material that I chose was PA12, and the parts were produced by HP MJF (Hewlett-Packard Multi Jet Fusion) whose process gave practical strength.

Then, I went hiking to test it…

[Nenta WAKO, Dr.Eng.]

matthew,

This camera has an excellent image stabilization. The background scene is not blurry, but my body looks blurry/shaking at impact. So, yes. I think putting a vibration insulator/damper between camera and stick might be effective.

[Ryan Jordan]

Nice work! I would buy a pack of these.

[Nenta WAKO, Dr.Eng.]

Ryan,

Wow, thanks for your comment!

I have replied to your email newsletter about the problem of UL packs on 25th August. Have you read it? It is about a novel backpack lumbar pad that transmits the load to the lower back effectively. I sent back to the newsletter directly, so, I don’t know you can receive it.

[Author]

Posts